Eero Mesh Adhesive Angled Wall Mount Holder – Easy To Install

ORIGINAL DESIGN

The only wall mount holder kit for the Eero Mesh Wifi system that turns it into a beacon, bathing your home of office in WiFi. Ideal for environments with a lot of obstruction (i.e. office cubicles), allows for better reception and range than just being left on a desk.

WALL MOUNT FOR BETTER WIFI

Get the most from our Eero Mesh WiFi system by placing it higher up on your wall for maximum range and reception. When left on tables, the low level doesnt provide for the ideal situation for your Eero to reach its full potential.

NO TOOLS, NO HASSLE- 3M VHB TAPE

Dont look for that drill or call your buddy over to make Swiss cheese of your walls, simply remove the tape backing and apply our mount to your desired location, wait at least 2 12 hrs for the VHB to reach max bond strength and youre good to go. 3M VHB tape is super strong and is very hard to pull off by hand when fully bonded, but can be easily removed with use of a hair dryer.

CUSTOM DESIGNED

Our cradle design has been custom made to the curvature of the Eero body shape, holding it firmly but with minimal footprint. Will look in any setting in your home or office.

DESIGNED FOR RANGE NOT INTERRUPTION

Our wall mount has been designed to not impede the WiFi signal of your Eero.

COMPATIBILITY

NOTE – Only works with original eero router, will not work with with eero 6/Pro 6/Pro/Beacon – check images for reference

WHATS INCLUDED

1. 1 x Eero Beacon 01 – Self Adhesive Holder
2. 3M VHB Tape – Pre-Attached

COMPATIBILITY

This hanger is compatible with the following Eero models:

1. Model: EERO Eero Original

Not Compatible with eero 6/Pro 6/Pro/Beacon

Max weight limit: Designed for use with Eero WIFI only

Read our 3M user guide here
Ensure you attach the hanger as per the instructions or your hanger will not preform to the best of its ability

All images are for illustration purposes only, Eero devices NOT included.